← All projects

05 — Reverse Engineering · Cost Reduction

DC Casting Moulds — Reverse Engineered in India, ₹24L → ₹7L

Root-cause investigation · Import substitution · 12 moulds replaced

Slabs coming off the DC caster were bent. Worked through the root cause from parameters to mechanical play to cooling — pinned it on uneven water flow across moulds. Reverse-engineered one imported Chinese mould and built all 12 in India for ₹7L instead of ₹24L.

₹24L → ₹7L

Tooling cost

−71%

Cost saved

12

Moulds reverse-engineered

Flat

Slab geometry restored

The brief

Slabs from the DC (Direct Chill) casting line were coming out bent. First suspicion fell on the casting parameters — temperature, casting speed, water temperature — so we rechecked every setpoint and found them in spec. Next hypothesis: play in the rope drum pulling the slab down. But the bends were appearing in different locations along the slab — a rope drum issue would produce the bend at a consistent point, not random spots. That left only one explanation: improper cooling. On close observation of the cooling circuit, water flow varied from mould to mould — and that was the real culprit. The moulds had to be replaced. They are copper, imported from China, and at ₹2L apiece for 12 moulds, the bill was ₹24L.

The approach

  1. 01Ruled out casting parameters (temperature, speed, water temp) by full re-verification against setpoints
  2. 02Ruled out mechanical play in the rope drum by mapping bend locations along the slab — random positions, not periodic
  3. 03Confirmed uneven water distribution across moulds as the true root cause through direct flow observation
  4. 04Bought one reference mould from China instead of all 12 — used it as the master pattern
  5. 05Sent the imported mould for compositional analysis, then sourced forged copper of matched composition in India
  6. 06Took precise measurements off the reference mould and machined all 12 replacements via CNC at an Indian vendor
  7. 07Installed the India-built moulds — water distribution now uniform across every cavity

Before / After

Drag the handle to compare

DC Casting Moulds — Reverse Engineered in India, ₹24L → ₹7L — afterDC Casting Moulds — Reverse Engineered in India, ₹24L → ₹7L — beforeBeforeAfter

Before: bent slabs coming off the caster. After: super-flat slabs once the new India-built moulds gave uniform water-side cooling.

What changed

DimensionBeforeAfter
Mould sourceImported from ChinaReverse-engineered in India
Tooling cost (12 moulds)₹24 lakhs₹7 lakhs
Water distributionUneven across mouldsUniform across all cavities
Slab outputBent slabs, random bend locationsSuper-flat slabs

Snapshots

The India-built copper mould — forged copper of matched composition, CNC-machined to the imported reference geometry.
The India-built copper mould — forged copper of matched composition, CNC-machined to the imported reference geometry.
A pair of finished reverse-engineered moulds, ready for installation on the DC caster.
A pair of finished reverse-engineered moulds, ready for installation on the DC caster.
After: super-flat slabs running off the line — uniform cooling, no bends.
After: super-flat slabs running off the line — uniform cooling, no bends.
Before: visibly bent slabs coming off the DC caster — the defect that triggered the whole investigation.
Before: visibly bent slabs coming off the DC caster — the defect that triggered the whole investigation.

Got a plant problem like this one?